1. If the sanitation garbage truck wants to go from the middle of the two vehicles, it must be to slow down its own speed and avoid any accidents. There is a tendency to stick closer to the left as much as possible so that you can determine the correct position. In fact, this is similar to the principle of vehicular parking. You can notice whether you can pass the left tire and the right tire. If the driver of the sanitation garbage truck driver has limited technology, then the best way is Wait until both sides of the vehicle have been completely smooth and open after driving in the past. 2. In fact, the sanitation garbage truck is on the edge of the road and judges the distance when it comes to parking. The principle used by other vehicles is similar. However, when the sanitation garbage truck is stopped, it should not be overly attached to the shoulder of the road, so as to avoid causing tires and road shoulders on the vehicle to cause paralysis. If necessary, it is possible to look through the rearview mirror to see the rear probe or It is the lane line to determine if the stoppage is too close to the shoulder. 3, in the other car or traffic jam, parking, you can use the outline of the front part of the sanitation garbage truck , to observe the front of the car behind the tire and to protect the location of the rear bumper to determine the distance of the vehicle. If there is the upper part of the rear bumper of the preceding vehicle, then the distance between the two cars is about one meter. If there is the lower part of the bumper of the preceding car, the distance between the two cars is probably It is between two meters. 4. When driving a sanitation garbage truck at ordinary times, it is necessary to develop a good habit of using the rearview mirror to observe the situation. The shadow of the car is able to occupy the entire part of the rear-view mirror. The distance between the two cars is about three meters. The car shadow accounts for two-thirds of the rear-view mirror. If the distance between the two cars is five meters, then the car shadow will occupy one-third of the rearview mirror.
NT APU Stainless Steel Drill Chuck, Application range: clip diameter: 0.5-16mm bit .Mechanical spindle and cutting tools and other accessories.High Precision NT shank Tool Holder ,balanced G6.3 or G2.5 For choose.We are specializing in the production of NT APU Stainless Steel Drill Chuck, we can to figure to sample processing, and perfect after-sales service and technical support. Looking forward to your cooperation!
Lathe Drill Chuck,Milling Nt Apu Drill Chuck,,Nt Apu Drill Chuck JINING QINFENG MACHINERY HARDWARE CO.,LTD , https://www.qftoolholder.com
How Sanitary Garbage Trucks Determine Vehicle Distance Well