Produce capacity: 10000pcs/monty
New Mitsuba Starter with 2 brush holder assembly
A starter motor works as follows:
When a current is supplied to the solenoid it engages the plunger.this moves the lever fork and in turn pushes the pinion on the starter motor drive shaft.
retracts. this moves the pinion away from the ring gear and the starter motor becomes inoperative.excessive cranking or vehicle faults resulting in the starter motor remaining engaged can result in excessive heat generation and the premature failure of the starter motor and/or its components.
Mitsuba Starter Mitsuba Starter,Mitsuba Starter Motor,Mitsuba Starter Rebuild,Mitsuba Electric Starter Ningbo zhongwang auto fittings co.,ltd , https://www.zowoparts.com
Brand: zowo
New o rebult: 100% new
Warranty: high quality, fully tested and 12 month warranty
Mitsuba starter motor, wholesale various high quality mitsuba starter motor products from zowo parts
Buy mitsuba starter for polaris utvs, atvs, pmdd, 12-volt, cw, 9-spline
the movement also closes high current contacts (brushes) for the starter motor which then begins to turn.together with the rotation and engagement of the pinion to the engines flywheel the starting process is complete.when the ignition switch is released and the current is no longer supplied to the starter motor the solenoid
Outlet valve gasket failure caused by failure
A R175A diesel engine in the spring before the overhaul of the maintenance of cylinder liner replacement, piston, piston rings, valves and races, connecting rod, the supply of three precision couplings, there are still difficult to start the fault, and barely started after the operation Strenuous, no significant increase in engine speed when fueling the door. The inspection found insufficient pump oil pressure, decomposition pump, found that the valve gasket was significantly scratched, and there is a fracture. Turned out to replace the original valve when the hand with a screwdriver pry out the valve gasket accidentally broken, so that the fuel pump high, low oil collusion, resulting in the failure. Replacement of a new oil valve gasket troubleshooting. As the oil valve gasket installed pressure, reduced diameter, tight hoop in the valve seat, pry easily damaged, therefore, the replacement of the oil valve valve should be replaced at the same time the gaskets.