Leisuwash Leibao 360 Automatic Car Wash
Leisuwash specializing in manufacture Automatic Car Wash Machine, Touchless Car Wash , Automatic Touchless Car Wash, touchless car wash equipment, robot car wash, smart car wash system, leisuwash 360, leisuwash leibao 360, laserwash 360, leisuwash touchless car wash machine, leisu wash touchless car wash automatic, leisu wash 360 high pressure touchless car wash equipment, robo car wash, touch free car wash, leisuwash 360 touch free car wash, leisuwash 360 price, automatic car wash price, leisuwash in malaysia, no touch automatic car wash machine.
Leisuwash 360 touchless car wash machine high intelligent high quality, with car wash + car care + drying process totally, each car wash takes time 1 minute to 5 minutes which depends on the car wash mode.
The newest LeisuWash inbay Automatic Car Wash raises the standard for Touchless Car Wash Equipment. With Revenue Enhancement and Total Cost of Ownership improvements being the main focus, this vehicle wash system delivers the industry`s best Return on Investment. Smart 360â„¢ Technology enables the car wash system to be responsive to the dynamic conditions in the wash bay and allows it to [think for itself", increasing up-time and optimizing the wash process.
Leisuwash 360,Leisuwash Leibao 360 Series,Smart Touchless Car Wash,Car Wash Leisuwash 360 Hangzhou Leisu Cleaning Equipment Co.,Ltd , https://www.leisuwashtouchless.com
Electric control valve failure and sensitivity solutions
Common causes of failure to prevent and eliminate the motor does not start No input power connected to the power supply disconnection or poor wire contact Change the wire or wire properly connected to the power supply voltage does not match or low voltage Check the voltage with the instrument thermal protection action (ambient temperature is high or use Frequency high) Decreases ambient temperature and reduces frequency of use or sensitivity Power capacitor is broken Replace power capacitor Error in input signal Replace input signal Self-stop on automatic operation Overload protection due to excessive load Check control valve Eliminates overload Thermal protection action and The same control valve inside the same bite foreign objects even manual operation is also very laborious, remove the valve packing gland over tightening try to loose gland manual operation laborious filling gland over tightening try loose gland valve accidental removal valve check Not showing the opening signal Opening signal line Poor contact or open wire Check the opening signal line connection signal does not reach the fully closed potentiometer Bad installation Check the installation of the potentiometer Limit switch Motor does not stop the upper and lower limits Given cam Poor adjustment and adjust the stopper bad contact more Change limit switch control sensitivity Decrease motor torque Decrease motor voltage Inspect the voltage with the instrument to make it normal Low or inconsistent supply voltage High sensitivity of oscillation Adjust sensitivity Potentiometer to reduce sensitivity Common causes of malfunctions Prevention and remedies Motor does not start No Input power connected Power supply disconnection or poor wire contact Change the wire or correctly connected to the wire Power voltage does not match or low voltage Check the voltage with the instrument Thermal protection action (ambient temperature or high frequency of use) Reduce the ambient temperature and reduce the use of frequency or sensitivity Power Capacitor is broken Replace Power Capacitor Input Signal Error Replace Input Signal Select Stop Automatically Overload Due to Overload Protection Check Regulating Valve Eliminate Overload Thermal Protection Action Same as above Biting Foreign Objects in Control Valve Even Manual Operation Very strenuous, disassembly valve packing gland over tightening try to loose gland manual operation laborious filling gland over tightening try to loose gland valve accidental removal inside the valve check did not show the opening signal opening signal line contact bad or off Line check open The signal line connection opening degree signal does not reach the fully closed potentiometer badly installed check the potentiometer installation limit switch motor does not stop the upper and lower limit given cam adjustment is poor readjust the limiter poor contact replacement limit switch control sensitivity reduce the motor Torque to reduce the motor voltage Insufficient voltage with the instrument so that the normal power supply voltage is low or inconsistent Oscillation sensitivity is too high Adjust the sensitivity potentiometer to reduce the sensitivity